|
 |
|
|
|
|
 Download
the PDF Data Sheet. |
|
|
|
|
| |
|
| |
 |
| |
|
| |
Which to Choose? |
| |
|
| |
Concerning these so very similar
and yet so distinctly different products, the real and fundamental
difference is QUALITY. While both types are stocked by us and both
are available in all tempers and quantities over 1 lb., the practical
problem of choice is... FIRST COST VS. FINAL COST. There are many
instances where the cheaper "sheet coil" will do and
all costs are considered at a savings. On the contrary, there are
many instances where "genuine strip steel only" will
do at a final cost less than sheet steel. |
| |
|
| |
| Select Sheet Coil |
|
Select Strip Steel |
- If sheet steel's broad tolerances
will do.
- If the fabricating operations are not too complicated and
do not require intricate, expensive dies.
- If high-speed production is not required.
- If fairly heavy,
oversize gauge variations are not objectionable.
- If a fine
surface finish is not essential.
- If a good base for paint
or enamel is desired.
- If wide variations in physical characteristics
are permissible.
|
|
- If strip steel's
close tolerances are required.
- If you wish to avoid rapid die
wear due to heavy oversize gauge variations.
If high-speed production methods are employed.
- If you want maximum "square footage" for
greatest parts yield per ton.
- If you require a fine finish or a better base for plating.
- If you must have a high degree of uniformity of chemistry
and physical properties - plus precision tolerances.
- If you want selected tempers for maximum strength and
lightest weight.
|
|
| |
|
| |
Both products are available
in coil and cut length and in all tempers and quantities of one
pound and over. |
| |
|
|
|
|
